This way, your workpiece can get caught by the blade on the end. Splitters are not as effective as riving knives, though, because they don't rise or go down as you adjust the blade height.ДЄs you can see in the image above, lowering the blade will create a very wide gap between the blade and the splitter. Fortunately, as per Underwriters Laboratories UL 987 Standard for Stationary and Fixed Power Tools, all table saws produced after 2008 must be fitted with riving knives that rise and fall with the blade.ДЇor older saws, you will want to at least use an insert with a splitter that will act similar to a riving knife and keep the workpiece from squeezing the blade. The only time when you should remove the riving knife is when you use a dado set. The good thing about it is that it goes up and down together with the blade, providing support regardless of what height the blade is set at.ДЄ riving knife should be installed at all times, even if you are just making singular cuts.

It prevents the workpiece from pinching the blade or touching its teeth on the back. A riving knife is a piece of metal that stays close to the teeth at the back of the blade. Modern table saws come equipped with safety features that are designed to keep you out of harm's way. This happens way faster than you can react.ДЇollow these tips to reduce the risk of hurting yourself from kickback on a table saw. Worst of all, your hand can get drawn into the blade and cause an amputation.

It then gets lifted up on top of the blade and thrown back at you with great force. When a piece of wood makes contact with a tooth at the back of the blade.Avoid this by making sure that the fence of your table saw is perfectly aligned in relation to the blade. As the blade spins, it can throw the workpiece back at you. A workpiece can also get stuck between the rip fence and the back of the blade.If your table saw is powerful enough, the blade can propel the board right at you or flip it up and hit you in the face. At best, this will lead to the stalling of the saw. A board can kick back during a rip cut when it goes halfway through the saw and the kerf starts pinching the blade.Table saw kickback usually occurs under these sets of circumstances: This usually occurs when the workpiece pinches the blade or gets stuck between the blade and the rip fence. Kickback is a situation when wood gets picked up by the blade and violently thrown at you, which happens way faster than you can react. Be attentive - Stay alert when working on a table saw.Check your blade - Maintain your blade and make sure it's sharp and straight.Do not cut crooked stock - Crooked boards can be dangerous to work with on a table saw.Use a push stick - This will give you better control and keep your hands away from the blade.Do not crosscut with the rip fence - Instead, use a miter gauge or a crosscut sled.Have basic safety features in place вЂ“ Always use a riving knife or at least a splitter.In this article, we will discuss the steps you can take to avoid kickback on your table saw.

According to the National Center for Biotechnology Information, table saws cause over 30 thousand injuries each year in the United States alone, with kickbacks being one of the main causes of accidents. While it is one of the most versatile tools in a woodworker's arsenal, it can be dangerous when used without care. A table saw should be approached with a healthy level of fear and respect.

Saw that doesnt cut fingers